Any mechanical equipment as long as the operation of a period of time, it is necessary to carry out some routine maintenance work, as the saying goes, "a dike of a thousand miles, destroyed in an anthill", the main purpose of our routine maintenance is to find the equipment in the equipment may affect the operation of the hidden dangers, and will eliminate them. Especially some key and important parts, must have a plan and purpose of some routine maintenance work, only so that the equipment is in good condition, to protect the safe operation of the equipment.

First, the installation of the machine notes:

1, the important condition of equipment installation is a horizontal carrier (ground or special platform) will be automatic gluing machine placed on it, and adjust the automatic gluing machine at the bottom of the fixed seat so that the gluing machine's worktable in a horizontal position, adjusted after the fixed casters to prevent the equipment from sliding because of inertia in the process of operation. (The marked part in the picture is the movable pedestal which can adjust the horizontal height.)

2, automatic gluing machine fixed is connected to the power supply, now on the market to sell the automatic gluing machine are basically using AC 380V power supply, (note that the power supply must be with the ground or else the whole frame of the equipment may be with static electricity) plug into the power supply, open the equipment inside the self-powered switch, and then touch the screen to select the 'File ' project, testing equipment to do a variety of action flexibility, (it should be noted that, in the test do not open the control box).

3, the next step connected to the gas pipe and to the rubber pipe, most of the automatic gluing machine is configured with the coating head control cylinder is a small square cylinder, this cylinder requires the ideal air pressure of 0.6MP should not be adjusted too large, the air pressure is too large words can easily lead to the cylinder movement is too violent, and affect the service life of the cylinder. Glue tank air pressure in the 0.6 - 0.8mp between good, (into the glue tank gas must be after air filtration and oil-water separation of pure air, otherwise it is easy to cause deterioration of the glue, but also easy to corrode some of the hardware of the equipment) in the out of the tube connected to the automatic gluing machine coater, take over the work is basically complete.

Second, the use of machine specifications.

This is a place worthy of our attention, that how to regulate the use of this automatic gluing machine? First of all, the use of equipment to pay attention to, not for the convenience of direct contact with hard objects to the touch screen, which directly affects the service life of the touch screen and touch screen sensitivity. In the operation of the equipment can not be artificially prevented by external forces to the running track of the coating head, but also pay attention to the distance between the coating head and the work surface can not be too close or too far to maintain a distance of 20CM is a good distance.

Third, notes.

In the equipment before the operation of the first check both sides of the running track and lateral track track there is no debris, there must be cleaned up in the operation of the equipment, check the equipment coated head there is no adhesive attached to the above, there should be cleaned up, or else coated out of the effect will be directly affected by the board rollers will also result in clogging. After the use of the equipment with the use of water or equipment suppliers to provide the cleaning fluid will be cleaned equipment plate stick can not have residue on the plate stick, if it is intended to long-term use of the equipment hose inside the glue should also be cleaned out to ensure that the next time the use of smooth, each moving parts should be rubbed with antirust oil to prevent rusting of movable parts to prevent the next use of the impact of the sensitivity.